Mechanical Design, Manufacturing and Engineering Forum |
[ Home ] [ Search ] [ Design Resources ] [ Product and Services Directory ] |
[ POSTING POLICY / RULES ] [ Archive#1] [ Archive#2 ] [ Archive#3 ] |
Forum Moderators: randykimball, Administrator |
|
Interference fit coefficient of friction | |||
Post Reply | Forum |
Posted by: mmc205 ® 11/15/2004, 07:38:05 Author Profile Mail author Edit |
I'm creating an interference fit calculator based off of Lame's Equation for thick walled cylinders, and I've derived it for my situation, but I can't seem to find good information or a good case study about the coefficient of friction in a interference fit. Is it just the coefficient between the two materials, or are their other mechanisms at work. Also, would the force to insert be the same as the retention force? From experience, it seems retention is always higher than insertion force. |
Post Reply | Recommend | Alert | Rate | View All | | Next | |
Replies to this message |
Re: Interference fit coefficient of friction | |||
Re: Interference fit coefficient of friction -- mmc205 | Post Reply | Top of thread | Forum |
Posted by: Cragyon ® 11/17/2004, 17:13:18 Author Profile Mail author Edit |
Check out the following links on engineers edge /friction_menu.shtml
|
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Re: Interference fit coefficient of friction | |||
Re: Interference fit coefficient of friction -- mmc205 | Post Reply | Top of thread | Forum |
Posted by: gumbo ® 11/15/2004, 21:56:52 Author Profile Mail author Edit |
Generally I just use the coeficient of friction values for the two materials but it is obviously dependent on surface finish as well. The insertion force will actually be the dynamic coefficient of friction once movement has started; whereas, the retention force will be based on the static coefficient. Note that in our applications we almost always utilize heat differentials to assemble press fits rather than try to press them together. |
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread | | | |
Re: Interference fit coefficient of friction | |||
Re: Re: Interference fit coefficient of friction -- gumbo | Post Reply | Top of thread | Forum |
Posted by: mmc205 ® 11/16/2004, 07:23:43 Author Profile Mail author Edit |
For my application, surface finishes will be 32uinch or better, however the parts will be gold electroplated, so I'm guessing i should use friction values for gold, while using the properties for the base material for all of the stress calculations. Thanks for the info |
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer