Posted by: prakash2004 ® 08/08/2004, 03:20:53 Author Profile Mail author Edit

Dear friends, How to find out the tolerence for the specific fit. Example : For 50 mm shaft dia with g6 fit, What will be the upper & lower limits. Is there any specific formula ? With warm regards, Prakash..........

Replies to this message

Fits & Tolerance of
Re: Fits & Tolerence -- prakash2004	Post Reply	Top of thread	Forum

Posted by: Cragyon ® 08/08/2004, 09:26:36 Author Profile Mail author Edit

The letter "g" refers to a lower limit tolerance variation. For 40 - 50 mm the limit would be -.009 for 50 - 60 mm the limit would be -.010 . I do not believe tolerance grades are based on a formulae.  Tolerance grades are based on experiment with the actual sizes and the resulting fits. Check the following pages for simular tolerance information on limits and fits: /international_tol.htm /general_tolerances.htm Hope this helps!

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread