screw conveyor design
	Post Reply		Forum

Posted by: freak_scil ® 06/08/2004, 08:50:56 Author Profile Mail author Edit

hi folks these days i m experiencing a problem that how i can calculate a screw in flat form which can meet the following parameters shaft size is 60 mm screw OD is 150 mm screw pitch is 170 mm now can some one help me in calculation of the ID of the screw if there is more help is available in this regard i m awaiting for the reply

Replies to this message

Re: screw conveyor design
Re: screw conveyor design -- freak_scil	Post Reply	Top of thread	Forum

Posted by: jcmcgraw ® 06/09/2004, 08:58:22 Author Profile Mail author Edit

If I am not mistaken, you can go back a few pages in the forum and find all the answers to your questions. If I remember correctly there is a thread on here that covers this same problem in great detail. Good Luck

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread