|
||||||||||||
|
||||||||||||
| process problem |  | ||
| Post Reply | Forum | ||
| Posted by: cnjbshi ® 03/21/2007, 08:13:59 Author Profile eMail author Edit |
Now I face one difficult technologies issue for make one part.
The part had large numbers of cavity_holes(1299 x dia0.64mm_deep=3.15mm)! The layout of holes is in one 34.08x34.08mm area. The pitch=0.7mm, When drill these holes,It could engender that extrusion each other. Could you give some help about how to avoid above issue? Thank you! |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| Re: process problem | |||
| Re: process problem -- cnjbshi | Post Reply | Top of thread | Forum |
Posted by: Olly ®  03/25/2007, 16:43:33 Author Profile eMail author Edit |
What a kind of material you should drill? |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
| Re: Re: process problem | |||
| Re: Re: process problem -- Olly | Post Reply | Top of thread | Forum |
| Posted by: cnjbshi ® 03/25/2007, 20:05:03 Author Profile eMail author Edit |
The material is plastic(Peek ESD). |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
| Re: Re: Re: process problem | |||
| Re: Re: Re: process problem -- cnjbshi | Post Reply | Top of thread | Forum |
Posted by: santo1964 ®  05/10/2007, 06:08:40 Author Profile eMail author Edit |
Laser OR water jet cutting is the best solution |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
| Re: Re: Re: Re: process problem |  | ||
| Re: Re: Re: Re: process problem -- santo1964 | Post Reply | Top of thread | Forum |
| Posted by: cnjbshi ® 05/10/2007, 23:03:15 Author Profile eMail author Edit |
Thank you! |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
