Tapered Motor Shaft and mating Boss Design

Tapered Motor Shaft and mating Boss Design
	Post Reply		Forum

Posted by: Elie

11/25/2002, 12:04:53

Edit

Hi All,I was wondering if any of you could help me out....I am desinging a product that uses a Hydraulic Motor that has a 30mm Dia..1:10 Tapered Shaft.I am designing a Boss that sits on the shaft and it tightened down with a castle nut and retained using a split pin.Can anyone point me in the direction of a standard for designing this interface.Regardselie

Post Reply | Recommend | Alert

Rate

| Next |