|
||||||||||||
|
||||||||||||
| Plated terminals Help needed | |||
| Post Reply | Forum | ||
| Posted by: ExactusBrad ® 09/07/2006, 18:37:05 Author Profile eMail author Edit |
I am currently working on a project which has a PCB with plated through holes that get press-fit on to a pressed metal terminal (originally specified as Nickel Plated Brass). Our manufacturing supplier has suggested the use of tin plated copper to reduce the cost.
Does anyone have an opinion on using either material? Keeping in mind the pressed metal part has to bind with the solder plated Fibreglass PCB. Thanks for any help |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| Re: Plated terminals Help needed | |||
| Re: Plated terminals Help needed -- ExactusBrad | Post Reply | Top of thread | Forum |
| Posted by: Kelly Bramble ® 09/08/2006, 19:47:45 Author Profile eMail author Edit |
If you conformal coat the board afteer assembly, this may be just fine. Check out /galvanic_capatability.htm for more information on galvanic capatability. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
