|
||||||||||||
|
||||||||||||
| Schedule 20 PVC |  | ||
| Post Reply | Forum | ||
| Posted by: Zan ® 06/27/2006, 14:40:37 Author Profile eMail author Edit |
Hello. First time to post on this forum so I hope I can get some help. I have something that I have been working on for some time now (which I must say has been quite a while). Anyway, most of my work thus far has just been pen to paper, so to speak, and now I want to build what I have envisioned. The only problem is that after caculating many varialbes one of the hardest to overcome is one key component of the system. I am looking for some form of plastic pipe. The diameters I am looking for is 8" and 10" OD. PVC will work but the cost is much too high for the system to be profitable down the road. I have contacted a few companies but as you may expect many to not have the time to help a poor ole soul like me. Does anyone here know of a company that deals in cheap plastic pipe with large diameters? I would also prefer thin wall pipe because it will be easier to work with. The pipe will not hold water or chemicals and does not need to be corrosion resistant. If anyone can point me in the right direction I would greatly appreciate it. Thank you for your time and attention. Zan |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| Re: Schedule 20 PVC | | ||
| Re: Schedule 20 PVC -- Zan | Post Reply | Top of thread | Forum |
Posted by: chaka ®  09/07/2007, 16:43:57 Author Profile eMail author Edit |
Hi Zan, If you are looking for plastic piping and other material you should try Seelye-Eiler plastics (MN) Chaka |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
| Re: Schedule 20 PVC | |||
| Re: Schedule 20 PVC -- Zan | Post Reply | Top of thread | Forum |
| Posted by: Scooter ® 06/27/2006, 15:06:36 Author Profile eMail author Edit |
You might try the PPI,(Plastic Pipe Institute) @:
www.plasticpipe.org. Plenty of Info. here. Thanks, Scooter |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
