Membership Services

How Plating / Finish is called out on drawings

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">B.J. Hughes on February 04, 2002 at 15:20:56:

Looking for a drafting best practice method of calling out plating requirements on drawings. Do I spell out the specific plating requirement or do I call-out a general plating note which refers to a seperate plating document? Looking for some kind of drafting standard practice which will work for purchased machined parts as well as parts which will be made in house. Also, should my dimensions be called out as "before plating" or "after plating"? Please advise. Thanks.
B.J.

Follow Ups

Re: How Plating / Finish is called out on drawings Randy 18:58:36 3/02/2002 (0)
Re: How Plating / Finish is called out on drawings K. Bramble 08:53:10 2/05/2002 (1)
- Re: Re: How Plating / Finish is called out on drawings Jim Disharoon 17:06:09 2/12/2002 (0)

Subject: Re: How Plating / Finish is called out on drawings

Comments:: Looking for a drafting best practice method of calling out plating requirements on drawings. Do I spell out the specific plating requirement or do I call-out a general plating note which refers to a seperate plating document? Looking for some kind of drafting standard practice which will work for purchased machined parts as well as parts which will be made in house. Also, should my dimensions be called out as "before plating" or "after plating"? Please advise. Thanks. : B.J.

[ Home ][ Forum Archive ] [ Active Engineering Forum ]