Results 1 to 2 of 2

Thread: E value for Phenolic LE

  1. 09-23-2015, 05:15 PM #1
    pnouth
    Guest

    Rolleyes E value for Phenolic LE

    Does any one got E value for Phenolic LE? Is it possible to use Flexural Modulus in place of Young Modulus for plastics?

    Regards,

    pnouth
    Reply With Quote Reply With Quote
  2. 09-24-2015, 08:48 AM #2
    Kelly_Bramble
    Kelly_Bramble is offline
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    E = Modulus of Elasticity? There are NEMA and MIL specifications that will cover minimum engineering requirements.

    Other than that, for Phenolic LE which is a Linen fill E is equal to about 850 to 1050 psi depending on whether the loading is with or against the filler.

    See: Phenolics Plastics Engineering Data Table
    Tell me and I forget. Teach me and I remember. Involve me and I learn.
    Reply With Quote Reply With Quote
« heat transfer- conduction problem | I am Making a combustion chamber for a engine with a pipe flange »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules